In This Project I was tasked to design a charm, for a client, and have it 3d Printed.
The restrains were:
The first Ideas given were:
There is two components to the Project: Part N and Part X
The restrains were:
- Had to be under 17000mm^3 in volume
- Client had to Approve the basic design by 11/26/22
- had to be at least 2mm thick plastic maintained around edges of holes.
The first Ideas given were:
- A) Cube of two initials that could split in half
- B) heart that was split down the center of the y axis
- C) heart that was split down the center of the z axis with initials on either side
There is two components to the Project: Part N and Part X
My engineering Notebook, Isometric Sketch, and Technical Drawings:
Last But not least, The Printed Part(s)!